You do not have permission to view this page
Please contact email@example.com for assistance or refresh the page to retry. If you are using a VPN please disable it.
10 out of 10.arrived well packaged. Very prompt. Bike runs alot smoother. Better idle to.well done.
I found the unit was a lot easier to set up than the traditional nanometers. The scaling was very good, but if your looking for perfection, I’d still go for mercury tubes, but unfortunately mercury is not easy to transport (planes etc.)
This is a workshop tool and as such should have a 240volt supply? Im not going to be tuning my bike on the side of the road so battery clamps are not acceptable! Banana plugs at the very least so I can plug it in to a regulated and inverted 240v AC/12V DC supply.
Thank you for your detailed feedback.
The reason why our devices run on 12 volt is that the the 12V vehicle battery right there where you are working.
It is our view that most of our customers prefer simply clipping onto the battery over having to reach for the nearest outlet, use an extension cord, and having to acquire a regulated and inverted 240v AC/12V DC supply, to use our product.
It is for these same reasons that you typically find other automotive workshop tools such as strobe lights, also running on 12 V.
We believe that our website clearly specifies the operating voltage and it shows a picture of the alligator clamps on the product page, but we will be taking your comments into account for the next update.
Again thank for your business and taking the time to provide your feedback!
Well made and does the job.
I just purchased a SyncroKing 6 had the opportunity to use it today on my Porsche 911 with independent throttle bodies. It worked well and very accurate. The throttle response is so much smoother and I was able to synchronise them perfectly. Thanks for designing and manufacturing this in Australia. Well done.